What spec. would I use for joint strength?

2017/2/28 19:03:42

Hello everyone, after a short layoff I am glad to be back. I have a question. I have a button (snap button) that is being soldered to a strip of sac coated copper. We are questioning the joint strength of this from our vendor as we see these popping off after we snap the intended connector on. What would I expect in pull strength, tensile strength etc. What spec. would I use? Any help would be greatly appreciated.
You might like

Andre Bosshard

  • Threads


  • Following


  • Followers


PCB Prototype

PCB Instant Quote

x mm


Quote Now

PCB Assembly