Via in edge of the PCB

Suggestions

Account

Get started now

My ALLPCB

My Orders Shipping Address Balance Account Settings My SNS Profile

2016/7/16 9:50:53

via pcb

If it's possible on Kicad to make via in the edge of the board? The goal is to make a connector.

henrik.svensk

2016/12/23 7:32:45

The solution is to trace the Edge. Cuts outline over a via, nothing special here.

Mario

2016/8/9 20:31:01

Yes, it is possible, the term you are looking for is "castellation". you can see the following picture clear.(有图）