The way of turning off GND airwires

Group Administrators: 0 | Group Member: 189 | Group Threads: 283

Initially PCBs were designed manually by creating a photomask on a clear mylar sheet, usually at two or four times the true size. Starting from the schematic diagram the component pin pads were laid out on the mylar and then traces were routed to connect the pads. If you have many questions of PCB Design, please come here!

Community > Groups > PCB Design Rules > The way of turning off GND airwires

Post A Thread

259

Telesound Bt.

How to toggle visibility of the GND airwires in the ratsnest?

2 likes

Likes

2016/9/14 8:53:04

Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

kelvint

As far as I know, the autorouter decides to connect ground pins on opposite sides of the PCB by long meandering tracks and takes up valuable signal routing space.

2016/11/1 23:03:38

eakkarach

Being able to highlight several nets and leaving the rest visible but not hiding the ones of interest would be a good solution.

2016/10/28 9:56:08

aesistemas

It's not a good idea to be able to dhide individual nets of the ratsnest. To remove them from the netlist is really a bad idea.

2016/10/15 21:39:42

Hot Threads

New Threads