Category:PCB PCB Manufacturing

Group Administrators: 1 | Group Member: 272 | Group Threads: 431

PCB manufacturing consists of many steps, such as PCB CAM, Panelization, Copper patterning, etc. This group is mainly talked about the problems during PCB manufacturing!

Thread Reply
Test of toner transfer Reply 2016-04-18 13:39:16
296 views
4 comments
12 likes

Arnold

Leave A Message

Follow

I did a comparative test of magazine paper and parchment paper. The parchment was cleaned with isopropyl before printing. Both transfer papers were taped to regular copier paper when printing to avoid crumpling and paper jams.
12 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

Agustin

Leave A Message

Follow

We can always apply proper heat. I have failures during learning time. But during then even, peeling it off was not an issue. Later I know the temperature setting and time duration to iron.

Mohamed Ramadan

Leave A Message

Follow

Have you ever tried a special A4 paper?

stefano.bellomo

Leave A Message

Follow

I have found the the cheap yellow papers to be good though some people say that it is not so good. But if you do not know what you are doing and apply too much heat from the cloths iron then the paper becomes difficult to remove.

Bruce

Leave A Message

Follow

I am a new beginner and looking for good info for study. The posted info is pretty good. I will share it with my friends.
ThreadReply