SPM AV Different Problem

2017/2/28 23:53:42

Ok here I go again. I got rid of the last problem but now I am back to a different problem. When the machine sits and I press Reset, the screen reads Starting the Z-axis Homing the Programmable squeeges and just stays there and does nothing. So I E-stop turn it back on and then reset it and it is fine. but then when I run boards after so long the back squeegee stays down and the front one stays up. I then have to turn the machine off again and reset and then it is fine for a little longer. If any one could help it is greatly appreciated.
Thanks
You might like

Luc Vercruysse

  • Threads

    10

  • Following

    0

  • Followers

    0

PCB Prototype

PCB Instant Quote

x mm

Quantity

Quote Now

PCB Assembly

SMT-Stencil