My Message
Suggestions
Hallo,
I have a problem with Topaz Xi with FNC nozzles. We have front, back and single camera in Topaz Xi. When i am using front camera and placing SO8, TSSOP14, TSSOP16 etc, using nozzles 73F the accurancy is ok. But when i switch to the back camera we have skew?
Does anyone from you has this problem and where is the problem. I can't get answer from Assembleon and they can't find the reason
Juan Matte
2/3/2017 11:31:13 PM
Very valuable!
Carr
2/3/2017 11:31:13 PM
Marvelous post. Appreciate it very much.
Nelson Souto
2/3/2017 11:31:13 PM
Truly enjyed reading your posts.
Darren
2/3/2017 11:31:13 PM
Quite useful and impressive info. I have learned a lot from your article and I will keep on reading your sharing.
James Kent
2/3/2017 11:31:13 PM
Glad to read such a marvelous article here. You are a genius.