Schematic design and non-PCB mounted com

Group Administrators: 1 | Group Member: 30 | Group Threads: 32

Schematic capture or schematic entry is a step in the design cycle of electronic design automation (EDA) at which the electronic diagram, or electronic schematic of the designed electronic circuit is created by a designer. This is done interactively with the help of a schematic capture tool also known as schematic editor.

Community > Groups > PCB Schematic > Schematic design and non-PCB mounted components

Post A Thread

Schematic design and non-PCB mounted components

402

Francisco

I am working on a bipolar power supply for hobby and educational purposes. Concerning the schematic, is it possible to place devices that don't go on the PCB in the schematic?

20 likes

Likes

2016/12/30 11:33:20

Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

adam

As the name suggests, electronics folder contains schematics and pcb file, along with generated BOM and gerber files.

2017/1/9 18:07:50

saulius.devyzis

You can put something on the PCB to connect to these components. Vias, pads, a connector, something. That something should be present on your schematics, since you'll have to use some footprint object in the PCB editor, and the component used in the schematics editor should correspond to the footprint object in the PCB editor.

2017/1/9 18:04:58

Hot Threads

New Threads