My Message
Suggestions
Hi all, Need advice how to fix RJ45 short issue after wave solder m/c .Few actions taken to resolve this issue but the outcome was inclusive which was 1. Modify wave pallet 2. Change conveyor setting from 0.8meter/minute to 0.7 meter/minute 3. Clear solder dross every 4 hours once. 5. Implemented template for post wave touch operator to inspect and touch up
Still found escapee for this short issue at ICT and FVT station. Please shade some light on How to eliminate this issue.
hgp
3/1/2017 8:59:09 PM
Remarkable.I have learned a lot from your post.
Chad
3/1/2017 8:59:09 PM
It was truly informative. Your post is very useful.Many thanks for sharing!
Frank Dembski
3/1/2017 8:59:09 PM
This post is really interesting.
Radu Seica
3/1/2017 8:59:09 PM
Impressive
Pedro Skou
3/1/2017 8:59:09 PM
Really appreciate your content.I hope you write again soon.