Thank you very much for your valuable suggestion! We will solve it as soon as possible!

PCB Design Rules

Group Administrators: 0 | Group Member: 189 | Group Threads: 284

Initially PCBs were designed manually by creating a photomask on a clear mylar sheet, usually at two or four times the true size. Starting from the schematic diagram the component pin pads were laid out on the mylar and then traces were routed to connect the pads. If you have many questions of PCB Design, please come here!

Community > Groups > PCB Design Rules > Problems of PCB designing
Problems of PCB designing
Reply
Alternate Text 305
Alternate Text 1
Alternate Text 14

Waelson Negreiros

For a 6 layers board designing I have some problems: Is it normal to route normal data through the ground plane? And all the VCC from source to device are connected using power plane. can I use this layer as well to route data using the power plane?
14 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

Neil Herbert

Thanks for your sharing.It helps me a lot.

Hot Threads

New Threads