There is a 0.5mm through hole, and 1.5mm pad in my PCB, but the manufacturer told me the cost need to increase because it is difficult to fabricate. Why it is hard to fabricate?
Why your thru hole component is so small?
And if it is for a component what is
the lead diameter and board thickness, and layer
count? This all needs to be considered for
manufacturability. You have not specifically descriped your question.
Ralph Hartwell
2016/12/2 21:21:39
Why your thru hole component is so small? And if it is for a component what is the lead diameter and board thickness, and layer count? This all needs to be considered for manufacturability. You have not specifically descriped your question.