My Message
Suggestions
Hi,
I am considering to use pressfit D-Sub and DIN connectors on a backplane. The IPC guideline does just cover pin protrusion for soldered pins, which have to be flush with the board as a minimum acceptable design. Yet, if the backplane may be thicker than the connector pins are long, they would not protrude so I wonder if that would be acceptable for a pressfit connector installation that is also secured with extra mounting hardware.
Borg
2017/2/4 21:18:12
Remarkable.It help me a lot. Thank you.
Spyros
2017/2/4 21:18:12
My friends and I have learned a lot with your post. And we will keep on following you for the further study.Hope your next article will come soon.
Fabrizio Restori
2017/2/4 21:18:12
Glad to read such a marvelous article here. You are a genius.
Miguel
2017/2/4 21:18:12
I certainly enjoyed reading your post.