Category:PCB PCB Industry Information

Group Administrators: 1 | Group Member: 146 | Group Threads: 374

This Group provides continually the latest information on the most recent trends, forecasts and analysis in the printed circuit board space.

Thread Reply
Making Circuits On A Stripboard Reply 2017-02-09 09:46:28
338 views
2 comments
33 likes

fernando.eulate

Leave A Message

Follow

A stripboard is a circuit board with holes and printed strips of metal.
These boards are a good way of connecting simple to medium complicated circuits. I highly recommend using stripboards in the beginning. They give you a lot of control of your connections and it’s relatively easy to fix errors.
Though when your circuit gets too many connections, it can be a real hassle keeping control of all the connections.

Soldering Components On A Stripboard

On the back side of the stripboard you can see several strips of metal. These connect the holes either vertically or horizontally.
First, place all the components on the stripboard according to the schematic. Try to use the connections already on the stripboard as much as possible.
If you have a lot of components, this might not be efficient. But always think through where you want to place the components before you start soldering.
After placing a component, bend its leads to make it stay in place when you turn the stripboard around to solder.
Solder all the components to the stripboard and make sure you have good solder joints all over.

Creating The Remaining Connections Using Wires

It’s very rare that you get all the connections you need just by using the strips on the board. So you will have to add some wires to create the remaining connections.
Create small wires by using a wire cutter. Cut a suitable length of wire and remove the isolation from both ends. This can be a bit hard with very short wires, so use longer ones if you have to.

What Kind Of Circuits Can I Build On A Stripboard?

You can build all kinds of circuits! You can find plenty of circuits to practice on from this page.
But a circuit with many connections can become a real hassle when you are trying to figure out which wire goes to where.
I usually recommend building a Printed Circuit Board (PCB) Design when you have a medium or more complicated circuit. This way you can first make sure all the connections are correct on your computer. Then you can get an exact copy of the board you drew on your computer.
Knowing this skill enables you to build much more advanced stuff =)
33 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

Vitor

Leave A Message

Follow

I really appreciate your content.Good resource for new beginners.

yashchabria

Leave A Message

Follow

Thanks for your intelligence. Pretty interesting and useful.
ThreadReply