Category:PCB PCB Design Rules

Group Administrators: 1 | Group Member: 178 | Group Threads: 275

Initially PCBs were designed manually by creating a photomask on a clear mylar sheet, usually at two or four times the true size. Starting from the schematic diagram the component pin pads were laid out on the mylar and then traces were routed to connect the pads. If you have many questions of PCB Design, please come here!

Thread Reply
How would I connect very fine wire which is 0.005" to a PCB? Reply 2017-01-19 14:17:24
246 views
1 comments
8 likes

Jason

Leave A Message

Follow

I have very fine gauge wire of 0.005", that's to say 0.127 mm diameter.

This wire is completely exposed. What can I do to terminate this to a PCB?
8 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

Conrad

Leave A Message

Follow

A great sharing for beginners. Thanks for your efforts and I will follow you and keep reading your posts.
ThreadReply