Category:PCB Assembly PCB Assembly Service

Group Administrators: 1 | Group Member: 251 | Group Threads: 383

In assembly the bare board is populated with electronic components, called a "printed circuit board assembly" (PCBA). In through-hole technology, the component leads are inserted in holes surrounded by conductive pads; In surface-mount technology (SMT), the component is placed on the PCB so that the pins line up with the conductive pads or lands on the surfaces of the PCB.

Thread Reply
how to charge battery with solar power? Reply 2017-02-28 11:07:45
230 views
4 comments
16 likes

Albert Palau Llort

Leave A Message

Follow

If i hook a 5amp/12volt solar panel to a 6 volt lead acid battery, would it recharge it? is it as simple as hooking the two together?
thanks
16 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

Csaba Simon

Leave A Message

Follow

Really appreciate your content. It quite benefits my learning and it has solved my puzzles completely. Thanks.

sam adnan

Leave A Message

Follow

The article has really peaked my interest.Hope you can write again soon.

Theo van Eijken

Leave A Message

Follow

Very impressive posting. Thank you for your efforts.

elecway000

Leave A Message

Follow

Very helpful and valuable.
ThreadReply