Category:PCB PCB Manufacturing

Group Administrators: 1 | Group Member: 276 | Group Threads: 436

PCB manufacturing consists of many steps, such as PCB CAM, Panelization, Copper patterning, etc. This group is mainly talked about the problems during PCB manufacturing!

Thread Reply
From etching to CNC drilling Reply 2016-10-20 10:26:33
216 views
3 comments
13 likes

Chris Holden

Leave A Message

Follow

Should I drill the mounting holes first with the cnc so as to create the mounting holes before transfering the image to the copper board?
13 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

vasilakism

Leave A Message

Follow

You can print both sides on one sheet of paper and fold it in half lining up fiduciary markers using a backlight, then put the board in between and run thru the hot laminator.

sami

Leave A Message

Follow

I think it shouldn't be that hard to align the board after etching. How big are the pads and the holes?

Indi

Leave A Message

Follow

You did a great job. Really appreciate your content.
ThreadReply