Category:PCB Assembly PCB Assembly Service

Group Administrators: 1 | Group Member: 251 | Group Threads: 383

In assembly the bare board is populated with electronic components, called a "printed circuit board assembly" (PCBA). In through-hole technology, the component leads are inserted in holes surrounded by conductive pads; In surface-mount technology (SMT), the component is placed on the PCB so that the pins line up with the conductive pads or lands on the surfaces of the PCB.

Thread Reply
DEK_265LT Reply 2017-02-28 20:03:00
302 views
5 comments
23 likes

giorgio.cannata

Leave A Message

Follow

DEK_265LT had been turn off and on by itsefl couple of time yesterday,and then off for good. I check the power going in to machine to the switch,got power to it,then power out to that little green box but there wasn't any power out put from that little green box. look like there wasn't any power going in to the transformer. any idea ??????? thanks
23 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

Mr. Atok Purnomo

Leave A Message

Follow

Impressive and helpful.

Cleber Toss Hoffmann

Leave A Message

Follow

I have share it with my classmates. They all appreciate it a lot.

nestandart

Leave A Message

Follow

Quite useful and impressive info.Thanks for marvelous posting.

Clare

Leave A Message

Follow

I am doing a new project. Your posting is pretty good and useful to my job.Thanks a lot. Hope you can write again.

leonard.roussel

Leave A Message

Follow

Very valuable!
ThreadReply