Category:PCB PCB Design Rules

Group Administrators: 0 | Group Member: 189 | Group Threads: 286

Initially PCBs were designed manually by creating a photomask on a clear mylar sheet, usually at two or four times the true size. Starting from the schematic diagram the component pin pads were laid out on the mylar and then traces were routed to connect the pads. If you have many questions of PCB Design, please come here!

Thread Reply
Copper pours and nets Reply 2016-04-29 12:21:18
306 views
1 comments
7 likes

Claudio Troiano

Leave A Message

Follow

There is a ground node copper pour on the bottom layer that automatically connected itself to all the ground pins on the PTH components,but the software stil show that those pads need to be connected together. How do I get it to acknowledge that they're already connected?
7 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

fravillama

Leave A Message

Follow

You can actually route them with a trace that will be hidden inside the plane.
ThreadReply