Can people let me know what reductions are typical for stencils. This can obviously be affected by the technology of the board, but for chip caps and R's do you use 1:1 and only reduce for finer pitch stuff ?
Your help would be appreciated.
3/1/2017 4:34:47 AM
luizleo2001
Threads
4
Following
0
Followers
0
henrik.svensk
3/3/2017 4:34:47 AM
Quite useful and impressive info. I have learned a lot from your article and I will keep on reading your sharing.
Gareth
3/3/2017 4:34:47 AM
This post is really interesting.
Cornell
3/3/2017 4:34:47 AM
Thanks for marvelous posting.
Robo Car
3/3/2017 4:34:47 AM
Have marked your post. Keep on your great job. Hope your next writing soon.
Berg
3/3/2017 4:34:47 AM
I think you are a genuis. The idea in your post is quite helpful and lights me. I have been puzzled for a long time in my new project.