4 layer PCB routing

Community Home
3199 Threads
7018 Posts
53 Groups

Category:PCB PCB Layout

Group Administrators: 1 | Group Member: 97 | Group Threads: 110

The connections on a PCB should be identical to its corresponding circuit diagram, but while the circuit diagram is arranged to be readable, the PCB layout is arranged to be functional, so there is rarely any visible correlation.

Join Group

Thread Reply

4 layer PCB routing Reply 2016-04-14 16:25:14

This Author Only Favorite Reply

294 views

3 comments

14 likes

Shahzad Rafiq

Leave A Message

I was thinking how I connect the ground and power planes to the connector and components that need them .

14 likes

Likes

Reply 2016-04-14 16:25:14

Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

Bob srfdeiasn

Leave A Message

You can use a via for your purpose. It is probably the power planes are internal. Use a via to connect from the signal planes to the internal power or ground plane.

Reply With Quote 2016-10-29 21:23:44

Technology lover

Leave A Message

Using a via can make connection with ground plane.In case of surface-mount component, there is separate via connected to the surface-mount pad. In case of throughole component, the pin is soldered into the via.

Reply With Quote 2016-08-17 06:43:09

Arcadia Lis

Leave A Message

If you put a big copper plane for ground on layer 2 and another one for power on 3 and assign them to the ground and power nets respectively. When you glood the copper, PADS will connect them as you want.

Reply With Quote 2016-05-24 16:47:00

Thread Reply

About Us: About ALLPCB; Why Us; News

Products & Services: PCB Capabilities; PCB Instant Quote

Beginners' Guides: PCB FAQs; Operation Manual; Earn ALLPCB Points

Official Bulletin: Disclaimer; Terms of Service; Privacy Policy; PCB Projects Sponsorship; Electronic Promotion Activity

Follow Us: Facebook; Twitter; LinkedIn; Google+; YouTube

Our Preferred Partners: