Thank you very much for your valuable suggestion! We will solve it as soon as possible!

PCB Design Rules

Group Administrators: 0 | Group Member: 189 | Group Threads: 284

Initially PCBs were designed manually by creating a photomask on a clear mylar sheet, usually at two or four times the true size. Starting from the schematic diagram the component pin pads were laid out on the mylar and then traces were routed to connect the pads. If you have many questions of PCB Design, please come here!

Community > Groups > PCB Design Rules > Non plated through hole to plated Through Hole
Non plated through hole to plated Through Hole
Reply
Alternate Text 331
Alternate Text 2
Alternate Text 16

alvaro.anton

I have defined Plated through holes on my PCB design.But somehow my pcb manufacturer has drilled it as non plated through hole and PCB has arrived.Now I need a suggestion to convert this non plated through hole to plated through hole using wire pin.
16 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

Radu Seica

The first you need to do is to find a PCB vendor and try to get them to remake the boards correctly.

filippo.lalli

If the holes edefined is correctly, then the fab should do a repeat run for free to correct their mistake, and they should do it expedited if you shout loud enough. However, this is not going to get you boards tomorrow.

Hot Threads

New Threads