Is there an easy way to stop the copper

Is there an easy way to stop the copper pour extending beyond the size of the dimension layer?

2016/4/15 9:08:16

pcb panel

I was panelizing some PCB boards. When I set the copper pour wire size to zero for easy placement, all the thermal wires had become zero. so there must be something wrong. but is there an easy way to stop the copper pour extending beyond the size of the dimension layer?

Prashanth Gunjur Munireddy

2016/8/26 7:23:39

Don't set the wire size in a polygon. With a width of zero the polygon may not even render correctly.

Barbara?Seria

2016/8/21 11:36:28

If you set the copper pour size to zero, it produces gerbers that cause problems. So don’t do that.

Achim Paulduro

2016/8/7 10:07:54

Copper pour wire size is thermal wire size. But copper pour wire size has nothing to do with placement. Set "orphans off", then the copper pour is limited with the dimension layer, as long as there are no pads outside the dimension layer. I usually place the copper pour polygone exactely where I want the borders.

robotszoft

2016/4/17 9:08:16

An interesting post.

Is there an easy way to stop the copper pour extending beyond the size of the dimension layer?

You might like