Category:PCB Assembly PCB Assembly Rule

Group Administrators: 1 | Group Member: 61 | Group Threads: 66

Join in this group and you will know many rules of PCB Assembly and solve the problems when in PCB assembly.

Thread Reply
reject percentage of assembled circuits Reply 2017-02-27 07:45:53
203 views
5 comments
18 likes

John Green

Leave A Message

Follow

This is a question for those of you who actually assemble components onto a board. Any idea what the "industry standard" is for fall out on assembled PCB's? I realize that the controls put in place in your processes will effect your overall quality. But I'm trying for a general answer. On pre-tested assemblies, should you expect to find defects in 1, 5, 10% of your assemblies? What's a common percent? If I find that 10 of out 100 tested need minor rework to function properly, is that high or about right? I would like to know if anybody else has a "watermark" on assemblies functioning after initial visual inspection. Any input you could offer would be appreciated. Thanks for your input.
18 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

alejandro.rostro

Leave A Message

Follow

Really appreciate your content. It quite benefits my learning and it has solved my puzzles completely. Thanks.

Cornell

Leave A Message

Follow

Thanks for marvelous posting.

Peter Sleeman

Leave A Message

Follow

You did a great job. Really appreciate your content.

fjqn

Leave A Message

Follow

Bravo! Hope you can write soon.

sam adnan

Leave A Message

Follow

The article has really peaked my interest.Hope you can write again soon.
ThreadReply