Category:PCB PCB Industry Information

Group Administrators: 1 | Group Member: 146 | Group Threads: 374

This Group provides continually the latest information on the most recent trends, forecasts and analysis in the printed circuit board space.

Thread Reply
Thermoplastic resin transfer molding Reply 2017-02-26 14:27:11
431 views
3 comments
30 likes

ErikLee

Leave A Message

Follow

This frame for the roof shell of theRoding Roadster R1sports car will be molded at K 2016 using KraussMaffei's new thermoplastic resin transfer molding (T-RTM) process, through which caprolactam is injected into a preform and then in-mold polymerized to create polyamide 6.
KraussMaffei Technologies GmbH (Munich, Germany) reports that it will introduce this fall at K 2016, in Düsseldorf, Germany, T-RTM, a thermoplastic resin transfer molding process that uses in-mold polymerization of caprolactam to produce near-net shape fiber-reinforced polyamide 6 parts.
At K 2016, KraussMaffei will demonstrate the production of a 500-mm-by-600-mm automotive structural component with metal inlays under series production conditions. Frames for the roof shell of theRoding Roadster R1sports car will be created in the exhibition booth several times a day to demonstrate the technology.
The T-RTM process begins in a press mold, where a continuous fiber preform (glass and carbon, 60% fiber volume fraction) is infiltrated with caprolactam. The caprolactam, as it is injected, is mixed with an activator/catalyst, which triggers the polymerization that transforms the caprolactam to polyamide 6.
"The production process on the KraussMaffei K 2016 exhibition booth will last about 2 minutes. The system is intended for high-volume projects and is designed for multiple-shift operations," says Erich Fries, head of the Composites/Surfaces business unit at KraussMaffei.
KraussMaffei says the low viscosity of caprolactam – similar to water – allows the matrix material to penetrate the fiber layers even at low internal mold pressures. For the application demonstrated at the exhibition, a clamping force of approximately 350 MT will be used. In addition, the high flow capacity allows the minimum wall thickness to be reduced and the fiber volume content to be increased to about 60%.
TheRodingpart being molded at K 2106 features a thermoplastic tear-off edge that is reportedly easily removed post-mold. KraussMaffei adds that the multi-preform concept minimizes fiber waste and allows a tailored fiber architecture.
CWwill be at K 2016 and will report again with additional information about this process.
Besides KraussMaffei, the following development partners were also involved in producing theRodingRoadster R1technology demonstrator: Forward Engineering (component design, hybrid concept), Alpex Technologies GmbH (T-RTM mold), Dieffenbacher (production of preforms/handling), Saertex (fiber layers), Henkel (bonding), Handtmann (aluminum inlays), TUM/LCC (fiber selection) and Keller (extraction technology).
30 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

don_peter

Leave A Message

Follow

Really appreciate your content.I hope you write again soon.

info

Leave A Message

Follow

It answered all my puzzles.Very helpful.

filippo.lalli

Leave A Message

Follow

I like checking your post and hope your update comes soon.
ThreadReply