My Message
Suggestions
Account
Account
Category:PCB PCB Design Rules
Initially PCBs were designed manually by creating a photomask on a clear mylar sheet, usually at two or four times the true size. Starting from the schematic diagram the component pin pads were laid out on the mylar and then traces were routed to connect the pads. If you have many questions of PCB Design, please come here!
I am using Altium Designner to learn PCB design having a basic question about PCB Rule set. Rule set is defined by the Altium, but can we edit the rule set according to our priorities?(view more)
Alex AlfonsoWith aluminum pcb, it can't transfer enough heat to cool down the temperature.I thought about using a ceramic pcb. Does anyone have experience with ceramic pcbs? Another question is that is there a...(view more)
Bartosz OrzechowskiActually,I've already finished my first PCB design by Eagle.I also expect my design can make the noise as low as possible. I wonder if someone is willing to check my design and find some mistakes from...(view more)
soulrevivalCan you suggest a way to clear routing in an area without removing placed components?(view more)
TzipiripiI have seen a way that people just poured a small amount of etchant over the pcb and rubbed the board with a sponge. I want to know can it work.(view more)
Garry ThornI use the calculators to find I have width values of around 1mm, or 1.7mm. But I've found out that some people use tracks of only 6mils. Why other people's trace widths are smaller than my?(view more)
Sebastien CRETENETAny third-party PCB design software that can combine gerber files to do panelization?(view more)
TsvetanWhen designing a high speed digital design including an FPGA and GSPS A/D interfaced with multi-gigabit/s serial ports. I have some questions like following: 1.When I use tools to calculate the imp...(view more)
Richard BaggaleyDesigning a PCB board computer that is very similar to a raspberry pi or an Orange Pi. It needs to have no ports aside from Ethernet. It should plug directly into an electrical outlet and have anot...(view more)
Antonio SemeraroActually I've never tried pcb desinging before,but now have to design a PCB by myself. Anyway,I could not find suitbale component in softwares like Eagle or KiCad.Do I have to make a custom component?...(view more)
Chester
Please send Gerbers to service@ALLPCB.com for quotation © ALLPCB.com,All Rights Reserved Privacy PolicySitemap
