Category:PCB PCB Assembly Service
In assembly the bare board is populated with electronic components, called a "printed circuit board assembly" (PCBA). In through-hole technology, the component leads are inserted in holes surrounded by conductive pads; In surface-mount technology (SMT), the component is placed on the PCB so that the pins line up with the conductive pads or lands on the surfaces of the PCB.
Hi, anyone here that can provide the DEK 07sp11 installation software. (or newest version for Typhoon series) ? I can't remember if the 07sp11 was a full installation or only a patch. If only a patch,...(view more)
Does the DRS-24 rework station take single or three phase 208/240? Thanks in advance.(view more)
Hello, I have a Juki 750L with a damaged hard disk. I need the machine software. If somebody have it, or a mirror copy of the hard disk.. Did somebody know where is located the offsets and setin...(view more)
We are in need of a small SMT printer able to double sided boards with an emphasis on fast changeover and the ability to have board supports. Our typical lot size is 1-20 pieces of rigid boards ...(view more)
Anyone know where can I find SF-820-LF reflow Hood (Electric Actuator cylinder)? Name: Controller Power Supple Input Voltage: 110V-220VAC Output Voltage:24VDC 50VA Type of Daty: 10%-50% We urgen...(view more)
Looking for a manual for a Cambridge or UMG AE2000 press machine if anyone has one. I need to get ours fixed but have no information.(view more)
having a problem with several heads miss picking 8mm feeder parts. Had to bypass 2 of the heads because it was becoming such a hardship. Heads 3, 4 (bypassed), and 8 (bypassed). On 3 and 8, it will mi...(view more)
I am looking to buy a Flexible magazine for a Mydata TP9-UFP I have seen both TMCFlex and TMDFlex magazines available, does anybody know the difference between the two and whether they are compa...(view more)
Hi has anyone had a fault with a soltec deltawave model 6622cc were the following functions all turn off for no reason Preheat zone1 and 2 the fluxer and the solder wave pump this has been happening f...(view more)
Hi Folks, I'm having issues with our dek Galaxy which is randomly having and reporting the error CAN Node Not Responding. Has anyone seen / fixed this error before?(view more)