Category:PCB Assembly SMT Stencil

Group Administrators: 1 | Group Member: 40 | Group Threads: 37

The purpose of an SMT stencil is to transfer solder paste to a bare circuit board. Before the assembly of the SMT components solder paste is printed onto the component pads of the printed circuit board by stencil, which are today usually manufactured from steel, more rarely from nickel or polyimide.

Thread Reply
Using metal squeegees w/Fuji GSPII Reply 2017-05-01 07:22:32
276 views
1 comments
4 likes

Indi

Leave A Message

Follow

Using metal squeegees on GSPs has caused premature stencil wear. Has anyone had any success with this combination? How much snap off did you use? We are using 5 mm pitch and have a no clean process.
4 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

babinyecz

Leave A Message

Follow

I am so glad that you shared this useful information with us. It is pretty helpful.Hope you can write again.
ThreadReply