Category:PCB Assembly PCB Assembly Service

Group Administrators: 1 | Group Member: 250 | Group Threads: 390

In assembly the bare board is populated with electronic components, called a "printed circuit board assembly" (PCBA). In through-hole technology, the component leads are inserted in holes surrounded by conductive pads; In surface-mount technology (SMT), the component is placed on the PCB so that the pins line up with the conductive pads or lands on the surfaces of the PCB.

Thread Reply
To Reflow boards with Bgas? Reply 2017-02-28 23:12:07
330 views
4 comments
28 likes

Albert Basson

Leave A Message

Follow

We built some boards with incorrect Bgas and we had to pull the bad ones off. I need to know if we need to bake the boards before we add the correct BGAs on and resend through the reflow? We need to get these boards shipped asap after we install the Bgas. Any info is greatly appreciated.
28 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

Brady

Leave A Message

Follow

Have marked your post. Keep on your great job. Hope your next writing soon.

kotec.shop

Leave A Message

Follow

Pretty good and useful info for beginners.

Bing

Leave A Message

Follow

I must say you have very interesting posts here.

nestandart

Leave A Message

Follow

Quite useful and impressive info.Thanks for marvelous posting.
ThreadReply