Category:Electronic Components Components Placement

Group Administrators: 0 | Group Member: 10 | Group Threads: 10

Component placement is an electronics manufacturing process that places electrical components precisely on printed circuit boards to create electrical interconnections between functional components and the interconnecting circuitry in the PCBs. The component leads must be accurately immersed in the solder paste previously deposited on the PCB pads.

Thread Reply
CP6 placement problems Reply 2017-02-27 22:03:16
259 views
5 comments
4 likes

szoke.szabolcs

Leave A Message

Follow

Hi,
I am having some problems with my Fuji CP6 placement repeat-ability.
The placement drifts during the build about .06-.10 mm on parts. It has happened on several different builds this week. It is enough to cause some defects after reflow on small parts (0402) and rnets.
I dial it in using double sticky tape and then after 3-5 boards it is off in the x again, usually back to where it was earlier. The Y has also needed adjustment, but not quite as much.
The PCB seems clamped securely. Part heights are correct. The machine is older 13714.5 hours on the counter One other symptom this morning is the 8 pin standard soic with 1.27mm pitch parts are way off in the x. .15-.20mm
4 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

Darren

Leave A Message

Follow

I have share it with my classmates. They all appreciate it a lot.

Sinan Atilla

Leave A Message

Follow

I must say you have very interesting posts here.

3447qii

Leave A Message

Follow

It is pretty helpful to my daily learning.

Andy

Leave A Message

Follow

You are a genuis!

Lukas Krehel

Leave A Message

Follow

Pretty good and useful info to my job. Keep on checking your post.
ThreadReply