BGA reflow profile

2017/2/1 13:42:32

We are about to run our first BGA devices and would appreciate some confirmation on a few points. First some details: PCB & Device: ============= 1) 16 layer (4 power, 4 gnd, 8 signal) 2) gold on nickel finish 3) ceramic BGA with eutectic balls Reflow equipment: ================= 1) 8 heating, 2 cooling zone DIMA hot air convection reflow oven (400mm wire-mesh belt width) From all I have read, I understand the following: ================================================= 1) I should paste the board - I have a .18mm (.007") stencil from which I get a uniform paste deposit (inspected under microscope) 2) Oven profile?? (help please??) - I understand that the board profile should be a standard one such as prescribed by the solder paste manufacturer. - is this correct. Some pointers would be really appreciated, as we are placing a $3000.00 device. I have some mechanical samples that I am able to experiment with.

Dana

2017/2/3 13:42:32

Thanks for marvelous posting.

Paolo

2017/2/3 13:42:32

Quite good posting. Your knowledge is quite impressive and useful to me who is new beginner. Hope you can write more posts and I will keep on reading.

theo_bestenlehner

2017/2/3 13:42:32

Glad to read such a marvelous article here. You are a genius.

alex

2017/2/3 13:42:32

A good piece of info for learning.

You might like

Nigel Nichols

  • Threads

    2

  • Following

    0

  • Followers

    1

PCB Prototype

PCB Instant Quote

x mm

Quantity

Quote Now

PCB Assembly

SMT-Stencil