ALLPCB will celebrate Mid-Autumn Festivals on Sep.24th and National Holidays from Sep.30th to Oct. 3rd.There is no DHL service during this time. Please kindly schedule your orders in advance in case of any delay. Sincerely sorry for any convenience caused ! Learn More
ALLPCB TEAM September 19th, 2018
Why it is bad if vias are too close to pads of the same Net?
Why putting a via near a pad of the same net makes a board non-manufacturable?
some people will worry about the via theiving solder from the SMD pad, if there is solder resist between the pad and the via this won't happen. Another reason is the width of the solder resist between the pad and via, this may be too small for the manufacturers tolerance.
Not the answer you're looking for?