Dear Customers,

ALLPCB will celebrate Mid-Autumn Festivals on Sep.24th and National Holidays from Sep.30th to Oct. 3rd.There is no DHL service during this time. Please kindly schedule your orders in advance in case of any delay. Sincerely sorry for any convenience caused ! Learn More

ALLPCB TEAM September 19th, 2018

close
Cart 0
Thank you very much for your valuable suggestion!
We will solve it as soon as possible!

A few questions about vias and pads on a pcb

2 1K

I am confusing with designing two layers pcb and have several questions of it. One question is about the utility of 2 layers pcb, is it to avoid using jump wires? I also want to know if you can still solder a component on the bottom layer even if the route is on the top layer? Are the layers linked somehow like vias thanks to the pads?

Follow Us: More
Jul 25 at 21:35
Lesley Manley

My suggestion is to try it with single layer pcb instead of going the easy way of the 2-layer board. If you don't succeed in doing this on a single layer, you'll never be able to do a more complex board on a 2-layer pcb either.

Sep 14 at 04:39
Kuznetsov Dmitry Aleksandrovich

The reason of using 2-layer pcbs is to avoid the jump wires. On a complex board there would be lots of them in all directions. Your layout doesn't need the second layer, which is simple enough to be routed on a single layer without wire bridges. If you get stuck you may have to move some components to another position, but it can be done.

Oct 20 at 04:00
contacto
1
15 30 50 per page

Your Answer

Not the answer you're looking for?

ask your own question.