Category:PCB Assembly Solder Paste

Group Administrators: 1 | Group Member: 186 | Group Threads: 220

Solder paste is a material used in the manufacture of printed circuit boards to connect surface mount components to pads on the board. It is also possible to solder through hole pin in paste components by print solder paste in/over the holes.

Thread Reply
Wave solder capability study Reply 2017-05-05 03:43:52
107 views
1 comments
14 likes

peter.moloi

Leave A Message

Follow

I wanted to know what other folks are doing for wave CpK studies. I thought that conveyor speed, preheat temperature, solder pot temp (never did see a large pt (>1500 lbs) vary by a couple of degrees) were standard. I thought that flux penetration into PTH barrel and solder pot immersion depth and solder pot parallelism would be also critical factors. We are using the ECD WaveRider to measure the implied solder depth and parallelism but wanted to know what other people are doing.
Also looking for Wave solder DOE citations. Haven't had any luck with googling and finding anything.
14 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

cgr-pcb

Leave A Message

Follow

Remarkable.
ThreadReply