Category:PCB Assembly Solder Paste

Group Administrators: 1 | Group Member: 186 | Group Threads: 220

Solder paste is a material used in the manufacture of printed circuit boards to connect surface mount components to pads on the board. It is also possible to solder through hole pin in paste components by print solder paste in/over the holes.

Thread Reply
How to rejuvenate solder paste? Reply 2017-03-01 00:24:22
176 views
5 comments
17 likes

Sergey Alexandrovich

Leave A Message

Follow

We use water soluble solder paste. When it gets a little dried out, can we add something to rejuvenate it? Liquid flux?
We do not place components, just print and reflow the solderpaste so solderballs, spattering, and other issues like those are of no concern. We just want to print the paste and reflow it into a meniscus on each smd pad.
When it gets a little dry it is difficult to print on the fine pitch (.4mm) foot prints so we wondered of we could "juice" it up a little to make it print better. Kind of like thinning paint when it drags!!!
Thanks in advance for your input.
17 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

Booth

Leave A Message

Follow

Remarkable.It help me a lot. Thank you.

javierdiazespana

Leave A Message

Follow

Quite useful and impressive info.

Juan

Leave A Message

Follow

Marvelous posting.

José luis cordoba

Leave A Message

Follow

Thanks for your intelligence. Pretty interesting and useful.

Remco Stoutjesdijk

Leave A Message

Follow

What you share on your post is quite useful.
ThreadReply