Category:PCB PCB Prototyping
PCB prototyping is the step before bulk production. There are many manufacturers, who offers PCB prototyping. How to find the most cost-effective PCB manufacturers with high quality and quick turnround?
What are good quality of life additions to a prototype PCB? I have come across a few nice additions such as: LEDs for power and micro activity. Test points at important places in the circuit. Conne... (See More)
The PCB fab have a 5x5cm minimum board size. My board is approx. 35x20mm so I can easily put two side-by-side and thus double the board count within this limit. What is the best way to do this? (See More)
There is a redidtor forgotten in prototyping, then I need to add it into a data line. The data line is a trace and carries low speed data. A through-hole resistor will be fine. The pins for both ends ... (See More)
I saw one prototyping board that was without copper through-hole vias, but instead had rectangular silver connectors that spanned multiple holes, the numbers are varied. It's almost like a quasi-brea... (See More)
I am aying out the PCB for first prototype, I am now thinking of laying out the power section but am wondering if I should just power it from an external supply. It is simple as it means I don't ha... (See More)
I'm planing to design a PCB for my robot assembly,actually I've never done that before, so I am opening to any of advices. (See More)