How to use a Prototype PCB
2016/11/27 9:07:21
Because of cost problem, I would use a prototype board. I have used those once before and it was a clear mess. I kept shorting IC pins while connecting lines to them fried a whole PCB. But it was a not so good experience. I attribute this failure to my incompetence in soldering on the prototype boards. I can do a clean solder on any PCB in a kit but I think prototype boards are a different ball game.
So I want to know do anyone have tips on using such boards?
Eugene Shamaev
2016/12/15 22:56:34
By using wire wrap wire you will reduce the amount of excess wire you have and reduce the chances of creating shorts, and make a good mechanical connection.
frmendozat
2016/12/4 14:21:24
What I do is to start with a piece of graph paper with a 100mil grid. You can set the components out and draw connections and start with a good layout plan.