Category:PCB PCB Prototyping

Group Administrators: 1 | Group Member: 21 | Group Threads: 33

PCB prototyping is the step before bulk production. There are many manufacturers, who offers PCB prototyping. How to find the most cost-effective PCB manufacturers with high quality and quick turnround?

Thread Reply
When I forgot a resistor on my PCB prototype, how do I add it? Reply 2016-11-01 16:41:29
121 views
2 comments
12 likes

Frederik

Leave A Message

Follow

There is a redidtor forgotten in prototyping, then I need to add it into a data line. The data line is a trace and carries low speed data. A through-hole resistor will be fine. The pins for both ends of the trace are exposed, but how do I add the resistor and remove the trace?
12 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

juan

Leave A Message

Follow

If your PCB has a solder mask you can fix this with an SMT resistor even when traces are close together. Cut the trace and scrape the solder mask away on both sides of the cut.

giuliocirilli

Leave A Message

Follow

I use a small screw driver for breaking the trace and scraping the solder mask off the two ends for my project.
ThreadReply