Is anyone aware of some guidelines regarding through-hole in SMT pads? One of our designers wants to add through-hole leads in some SMT pads for an inductor. The size of the hole is 0.032 inches and takes-up approximately 25% of the pad area. This SMT component would be reflowed. I am concerned about the paste volume being sucked down the hole.
joffrey.perez.jp
2017/2/4 5:06:07
I appreciate your article very much. Wait for your next writing.
julien.brasart
2017/2/4 5:06:07
My favorite psot here. Its very impressive and helpful.
Lukas Krehel
2017/2/4 5:06:07
Very interesting post.
Fatih YASAR
2017/2/4 5:06:07
I am going to keep checking for new writings.