Category:PCB PCB Equipments

Group Administrators: 1 | Group Member: 63 | Group Threads: 69

All of the pcb manufacturing equipments is supposed to provide high quality PCB assembly solutions for high mix, small to medium batch requirements.The manufacturing facilities should be continously invested to increase efficiency and maintain product quality.

Thread Reply
DIY PCB Fixture Reply 2017-02-22 21:39:42
243 views
1 comments
29 likes

Dana

Leave A Message

Follow

(Yeah, we don’t know what that title means either.) But holding your PCBs down in one place and nicely registered while you spread solder paste over them is a problem that needs solving, and [Carsten] did it nicely.
High volume PCB manufacturers have expensive screen printers to do this. The standard hardware hacker solution is to tape some scrap PCBs of the same thickness down to the table to hold the PCBs solidly in place. But if you’re doing a large run, and if you’re already firing up the laser to cut out mylar stencils, you might as well cut out some PCB-holding fixtures to match.
[Carsten]’s blog entry is short on details, but you get the idea just from looking at the picture, right? Adding registration pins to the holder that engage with the stencils could make this a real time-saver as well. As long as you’re lasering the stencilandthe holder, there’s nothing stopping you. It’s a simple idea, but a good one, so we thought we’d share. Our only remaining question: what’s a Karate Light?
29 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

Indi

Leave A Message

Follow

I am so glad that you shared this useful information with us. It is pretty helpful.Hope you can write again.
ThreadReply