Category:PCB PCB Design Rules

Group Administrators: 1 | Group Member: 160 | Group Threads: 272

Initially PCBs were designed manually by creating a photomask on a clear mylar sheet, usually at two or four times the true size. Starting from the schematic diagram the component pin pads were laid out on the mylar and then traces were routed to connect the pads. If you have many questions of PCB Design, please come here!

Thread Reply
Necessary work before PCB design Reply 2017-05-16 17:02:38
123 views
1 comments
3 likes

Laszlo Toth

Leave A Message

Follow

1. Carefully check the schematic diagram:

any printed circuit board design is inseparable from the schematic. The accuracy of the schematic is on the premise that the printed board is correct. Therefore, in the printed circuit board design, the signal integrity of the schematic must be carefully and repeatedly check to ensure that the device is properly connected to each other.

2. Device selection: 

the selection of components is a very important part of designing board. The package may be different for the devices of same function and parameters. The package is not the same, so the device welding hole is not the same. Therefore, please be sure to determine the package of various components.

Selecting components for multi-layer board must be positioned in SMD, which is widely used in various electronic products with its advantages of miniaturization,high reliability and installation automation.In the device selection, the characteristics of the device parameters should meet the needs of the circuit, the supply of devices should avoid the device shutdown problem; many domestic devices, such as chip resistors, devices and other quality have gradually reached the level of imported devices, and enjoy adequate supply, short delivery time and other advantages. Therefore, under the permission of circuit conditions,you should try to consider domestic devices.
3 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

Daniel Gilbert

Leave A Message

Follow

First step is always vital to a successful work.
ThreadReply