Category:PCB PCB Design Rules

Group Administrators: 1 | Group Member: 160 | Group Threads: 272

Initially PCBs were designed manually by creating a photomask on a clear mylar sheet, usually at two or four times the true size. Starting from the schematic diagram the component pin pads were laid out on the mylar and then traces were routed to connect the pads. If you have many questions of PCB Design, please come here!

Thread Reply
PCB Design Tools Improvement Reply 2017-02-12 20:29:27
365 views
1 comments
64 likes

Fabrizio Restori

Leave A Message

Follow

Anyone who has worked on a system design lately knows that creating a printed-circuit board (PCB) is no longer simple. Differential signals and multiple layers are the norm. RF is needed for Bluetooth, Wi-Fi, Zigbee, Z-Wave, and more. Signal integrity is as important as making sure the right pins are connected together.
Likewise, boards are more complicated. More layers are often needed to address the density of systems-on-chip (SoCs) that have hundreds of balls packed into an ever-tighter space. This complexity lends itself to automatic routing, but many designers still prefer manual routing because it can address issues that are sometimes hard to quantify to a program.
Companies like Altium, Cadence, Zuken, and Mentor Graphics have PCB layout programs designed to address these issues. Mentor Graphics’ latest Xpedition xPCB Layout simplifies interactive routing of differential signals (Fig. 1). Its high-level, hierarchical placement tool can operate in 2D and 3D modes (Fig. 2).
Xpedition’s 3D mode and mechanical enhancements allow designers to address the 3D aspects of a design, not just the circuit layout issues. The system can perform automatic placement and management. Yet its auto-assisted routing and customizable multi-pass autorouting impressed me the most when the company demonstrated its latest software. Auto-assisted routing is an interactive process. Just start from a pin and drag the cursor to about where the path should be and watch the results.
Running differential pairs was just as easy. The “multiplow” process lets a designer adjust a collection of paths like a data bus in one step. It keeps the paths in sync with each other, providing the nice, parallel layout that is usually the result of a fully manual but time-consuming process. The system can even be programmed to allow arcs or angles when required for tight routing like around ball-grid array (BGA) balls. The push and shove manual/auto-assist works in 3D mode with objects like chips too.
I have not laid out a board in a couple years. But if it is this easy, I might try again soon.
64 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

ventas

Leave A Message

Follow

I really appreciate your content.Good resource for new beginners.
ThreadReply