Category:PCB Assembly PCB Assembly Service

Group Administrators: 1 | Group Member: 249 | Group Threads: 393

In assembly the bare board is populated with electronic components, called a "printed circuit board assembly" (PCBA). In through-hole technology, the component leads are inserted in holes surrounded by conductive pads; In surface-mount technology (SMT), the component is placed on the PCB so that the pins line up with the conductive pads or lands on the surfaces of the PCB.

Thread Reply
Anyone use glass filled nylon connectors? Reply 2017-03-01 01:41:04
157 views
1 comments
25 likes

azhar

Leave A Message

Follow

Anyone use glass filled nylon connectors utilising the intrusive reflow techique (pin in paste). We are having probe with them becoming brittle after reflow- apparently due to moisture. We are also seeing bubbling on outside plastic.Peak oven temp 224 degrees. Glass content 43%. Has anyone used this type of material before and what did you do to solve the problem?
25 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

g.laliberte

Leave A Message

Follow

It is pretty helpful to my daily learning.
ThreadReply