Category:PCB Assembly PCB Assembly Service

Group Administrators: 1 | Group Member: 249 | Group Threads: 393

In assembly the bare board is populated with electronic components, called a "printed circuit board assembly" (PCBA). In through-hole technology, the component leads are inserted in holes surrounded by conductive pads; In surface-mount technology (SMT), the component is placed on the PCB so that the pins line up with the conductive pads or lands on the surfaces of the PCB.

Thread Reply
how often the optical sensor goes bad on the CS-400E machines Reply 2017-03-01 01:22:43
150 views
3 comments
30 likes

Ricardo Medda

Leave A Message

Follow

Does anyone know how often the optical sensor goes bad on the CS-400E machines. I have 2 machines and it seems that the optical correction does not work anymore. I keep getting an optical correction error, when the mode is turned on the correction does not see the PTH and says to recenter. I was wondering if anyone else out there has had this problem or knowledge of the failure rate of these optical sensors.
Thanks
30 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

Frank Dembski

Leave A Message

Follow

It answered all my puzzles.Very helpful.

Brady

Leave A Message

Follow

Nice sharing. What you share in this article is very useful. I will follow you and keep reading your posts.

Cyril

Leave A Message

Follow

Really appreciate your content. It quite benefits my learning and it has solved my puzzles completely. Thanks.
ThreadReply