Category:Electronic Components Cables & Connectors

Group Administrators: 1 | Group Member: 23 | Group Threads: 20

PCB design is a complex process, including schmatic, chassis and cables and connectors, ect. How to deal with cables and connectors when designing PCBs? How to get a successful pcb design?

Thread Reply
Compression-Mount Can Be Used for Test Connectors Reply 2017-02-13 20:57:01
367 views
1 comments
39 likes

Sezgin KIR

Leave A Message

Follow

Molex has developed precision 2.4 mm compression-mount test connectors, touting them as the industry’s only high-speed vertical PCB launch configuration operating to 50 GHz. The unique vertical PCB launch configuration gives the 2.4 mm test connectors key advantages over more traditional end-launch connectors. They have a smaller footprint and can be mounted anywhere on the PCB for increased density. Additionally, the compression-mount design eliminates soldering, resulting in reduced installation time. The design uses two 0-80 UNF screws so that the receptacle can be mounted directly to the PCB. It also can accommodate a range of board thicknesses from 0.57 to 2.79 mm and provides a continuous ground connection between the connector and PCB. The connectors mate to 2.4 mm male connectors, which are available on the customer’s test equipment cable end. The integrated center pin design allows 1.2:1 VSWR at 50 GHz and provides low reflections for accurate measurements. The stainless steel body can withstand over 500 mating cycles.
39 likes
Statement: This post is only the personal view of the author and does not represent the opinions of ALLPCB.com.

Adrian Voroniuc

Leave A Message

Follow

Interesting!
ThreadReply