Quote by Sales
Cart 0
Thank you very much for your valuable suggestion!
We will solve it as soon as possible!

The problem of PCB, power

2 1K

There is a basic PCB seems the only difference is someone has added the power cable to the “f1” not sure why , now is exactly the same board apart from the power wires that someone soldered on! Mine has a 3a 125v lf459 fuse where the “f1” is on the board. I have tested the psu and it gets 24v power. I gets 24v power when tested the 3 big lumps of solder that are on the psb. It looses power passed the 3a 125v fuse that the place marked “F1” so I tested the fuse doing a continuity test and it failed so I guess that has blown, I have ordered Micro Pico Fuse Time Delay / Slow Blow Axial 3A 125v to replace that.Should I just replace the fuse and see what happened?

Follow Us: More
Sep 4 at 11:40
Alvydas Sidlauskas

Probably be better if the fuse was faultyProbably be better off hoping the fuse was faulty Fuses are very good of protecting electrical components. but not so much with electronic components, such as transistors, ICs, etc. where operating currents are often in the low mA range.

Sep 22 at 05:21
sigibit

The F1 position is meant for a fuse.If there are someone put those wires there to use with an outboard power switch.You can remove them and put a fuse in. The fuse end clips appear to be missing, too, so you might have to use an inline fuse holder. I doubt that the coil is bad,it's usually pretty obvious. If the fuse blows for no apparent reason, the problem is most likely to be a semiconductor.

Oct 17 at 19:23
Beetlesmart
1
15 30 50 per page

Your Answer

Not the answer you're looking for?

ask your own question.