Quote by Sales
Cart 0
Thank you very much for your valuable suggestion!
We will solve it as soon as possible!

4 layer PCB routing

3 777

I was thinking how I connect the ground and power planes to the connector and components that need them .

Follow Us: More
Jul 5 at 17:28
Shahzad Rafiq

Include a couple registration marks, or use some vias or through-holes for alignment. Attach one side, drill the holes, then use those holes to align the other side.

Sep 13 at 18:55
Marco

Use two points on the pcb as reference points, drill, and align each separately. Hold both pieces up to the light, get both aligned, and staple or tape end of sheets together so it folds like a notebook. This requires an extra two inches or so on the end to allow flexing around the end of the board. Sometimes I also tape it to the board to keep it aligned.

Oct 16 at 20:18
Rob

My method was to stick each side down onto an L shaped piece of scrap PCB. So that you can remove parallax errors between the layers and get much better registration.

Nov 21 at 02:13
Jason Williams
1
15 30 50 per page

Your Answer

Not the answer you're looking for?

ask your own question.